Jeep Enthusiast Forums banner
83 views 4 replies 4 participants last post by  Shark_13  
#1 ·
Hi!! Trying to get the old stubborn girl to start but I’m not having any luck. The spark plugs are showing no spark and when I hooked up a fuel sensor reader it’s not picking up a reading. She alllllmost starts. But obviously won’t fully turn.
This week I replaced the water pump, distributor cap, spark plugs and wires, her ignition cylinder and thermostat. Tried a new ASD relay but saw no difference. Not really sure what to check next and why I have no spark and no fuel pressure
 
1993 Jeep Grand cherokee owns
Rebuild
#4 ·
kg6mov suggested you remove the ignition coil wire from the distributor cap, insert a spark plug into the hole where said wire plugged into the distributor cap, and repeat your spark test. If you get spark out of the coil but not out of the distributor, then you have a distributor cap and/or rotor burned up. Your reply was a bit ambiguous, maybe that's what you did, not sure.